Is it possible to use the XCP gateway on ETAS hardware (e.g. 593.1) without BOA driver?
The Ethernet interfaces of the ETAS hardware behave practically like an Ethernet switch and forward the measurement data to the measuring computer. Using the XCP gateway on the ETAS hardware is therefore possible without any problems even without an installed BOA driver.
Nevertheless, the following must be observed:
- The IP address of the gateway and the network card used to connect the ETAS hardware must match.
- The gateway is connected via the K405-xxx from CSM.
- The connected measuring modules do not have to be supplied separately. This is done via the ETAS hardware.