A wide range of accessories is available for the CSM measurement modules and data loggers, such as the USB to CAN interface CSMcan, system and signal cables, plugs, sockets, mounting materials, antennas as well as memory cards.
The system cables, for the engine compartment-mounted CSM MiniModules (CAN bus- and EtherCAT®/ Ethernet networking as well as power supply), are specifically made for this purpose. They are designed for high interference resistance and the lowest possible internal resistance of the supply lines as well as wide operating temperature ranges. The cables are flexible and extremely resistant to chemicals, including fuel and oil.
Do you have special wishes and requirements? Please do not hesitate to contact us.
With the CSM Supply Unit HIOKI, HIOKI current sensors, e.g. current clamps, can be easily connected to CSM measurement technology for current measurements in 12 V /48 V vehicle electrical systems and HV environments. The supply unit provides the necessary supply voltage and allows direct connection to CSM measurement modules.
Measurement modules should be calibrated at regular intervals to ensure compliance with measurement tolerances. If many modules are used in parallel and very frequently, a separate calibration station can be beneficial. In addition to a calibration hardware, this also requires suitable software: CSM offers appropriate calibration software developed in-house for its modules.
CSMcan is a cost-effective CAN bus interface with USB port for the data acquisition and visualization software vMeasure from Vector Informatik/CSM.
The high risk potential during measurements in high-voltage environments requires an enhanced safety awareness. This means: The user’s life and health should be put in the first place.
