☰ Menü

Support Support

Why is it not possible to set a 120 Ohm full bridge on a HV STG4 pro at 10 V bridge excitation?

Due to the too high power consumption it is not possible to use a 120 Ohm bridge resistor at 10 V supply voltage. The user is informed of this fact when attempting such a configuration from Config 9.1.0.

FAQ General

FAQ General

Questions and answers on CSM products.

FAQ CAN

FAQ CAN

Questions and answers on CSM CAN Modules.

FAQ ECAT

FAQ ECAT

Questions and answers on ECAT Measurement modules.

FAQ ECM

FAQ ECM

Questions and answers on Exhaust measurement modules.

FAQ CSMconfig

FAQ CSMconfig

Questions and answers on our software CSMconfig.

FAQ UniCAN

FAQ UniCAN

Questions and answers on UniCAN data loggers.

FAQ INCA AddOn CAN/ETH

FAQ INCA AddOn CAN/ETH

Questions and answers on our software INCA AddOn CAN/ETH.