UniCAN 0149 - How can I establish the USB connection to the logger without constantly running a measurement?

How can I establish the USB connection to the logger without constantly running a measurement?

Switch off the logger, remove the CF card and then connect it to the computer via USB. Connect the logger to the power supply and start the logger with terminal 15 until the connection is established. Then terminal 15 can be disconnected again.

Now the logger has an active USB connection and there is no parallel measurement.

FAQ General

Questions and answers on CSM products.

FAQ CAN

Questions and answers on CSM CAN Modules.

FAQ ECAT

Questions and answers on ECAT Measurement modules.

FAQ ECM

Questions and answers on Exhaust measurement modules.

FAQ CSMconfig

Questions and answers on our software CSMconfig.

FAQ UniCAN

Questions and answers on UniCAN data loggers.

FAQ INCA AddOn CAN/ETH

Questions and answers on our software INCA AddOn CAN/ETH.