☰ Menü

Support Support

Why does the calibration date not always appear in the CSMconfig report?

If you explicitly read out the module via the device dialog you can check a calibration date in the module. If no calibration information is displayed in this dialog, then none is stored in the module.

Note: Calibration information is not stored in the A2L file but only in the module. If an A2L file is loaded and a report is generated it does not contain any information about the calibration.

FAQ General

FAQ General

Questions and answers on CSM products.

FAQ CAN

FAQ CAN

Questions and answers on CSM CAN Modules.

FAQ ECAT

FAQ ECAT

Questions and answers on ECAT Measurement modules.

FAQ ECM

FAQ ECM

Questions and answers on Exhaust measurement modules.

FAQ CSMconfig

FAQ CSMconfig

Questions and answers on our software CSMconfig.

FAQ UniCAN

FAQ UniCAN

Questions and answers on UniCAN data loggers.

FAQ INCA AddOn CAN/ETH

FAQ INCA AddOn CAN/ETH

Questions and answers on our software INCA AddOn CAN/ETH.