Support
Support
Usually, the CAN-ID for CSM measurement modules is defined for a group of channels. Often valid for the entire module. This then occupies a consecutive range of CAN identifiers.
For some measurement modules, however, the CAN identifier and transmission rate can also be specified per channel. CAN identifiers can be defined channel by channel individually. However, the format (11/29 bit) must correspond to the CAN bus definition.
The option to define CAN identifier and transmission rate per channel is activated in the "Device Configuration" dialog or in the "Device List" view.
Restrictions for single channel configuration:
Questions and answers on CSM products.
Questions and answers on CSM CAN Modules.
Questions and answers on ECAT Measurement modules.
Questions and answers on Exhaust measurement modules.
Questions and answers on our software CSMconfig.
Questions and answers on UniCAN data loggers.
Questions and answers on our software INCA AddOn CAN/ETH.