Support
Support
The offset correction via adjustment in CSMconfig takes place in the DBC/A2L file and not in the module. This means that new scaling values are stored in the DBC/A2L file after the offset adjustment has been carried out. If an offset correction is desired during the measurement, it is better to use a function of the measurement software.
The only exception: Remote zero adjustment via CAN message with particular revsions of CAN ADMM8 pro/ADMM8 pro2 .
Questions and answers on CSM products.
Questions and answers on CSM CAN Modules.
Questions and answers on ECAT Measurement modules.
Questions and answers on Exhaust measurement modules.
Questions and answers on our software CSMconfig.
Questions and answers on UniCAN data loggers.
Questions and answers on our software INCA AddOn CAN/ETH.