FAQ 0053 - The STG CAM MM does not perform a remote bridge adjustment to the specified CAN ID?

The STG CAM MM does not perform a remote bridge adjustment to the specified CAN ID?

Unlike the ADMM CAN, the STGMM CAN does not react to a message with any content. The CAN message, which is to trigger the calculation of the zero offset for the respective channel in the measurement module, must have the following content:

Module type	DLC	Byte 0	Byte 1	Byte 2	Byte 3	Byte 4	Byte 5	Byte 6	Byte 7
STG CAN MM	8	0	0	0	0	0x7A	0x65	0x72	0x6F

FAQ General

Questions and answers on CSM products.

FAQ CAN

Questions and answers on CSM CAN Modules.

FAQ ECAT

Questions and answers on ECAT Measurement modules.

FAQ ECM

Questions and answers on Exhaust measurement modules.

FAQ CSMconfig

Questions and answers on our software CSMconfig.

FAQ UniCAN

Questions and answers on UniCAN data loggers.

FAQ INCA AddOn CAN/ETH

Questions and answers on our software INCA AddOn CAN/ETH.