Skip to main content

Support Support

Why do the ECAT modules work in CSMconfig but not in the measurement software (e.g. CANape, INCA)?

CSMconfig uses a simplified mode for configuration operation. CSMconfig and the XCP-Gateway establish a communication via a special IP adress and a broadcast command.
The measurement software in which the CSM ECAT are integrated does not support this simplified mode. In the measurement software the interface properties (IP adress) must match. If there is a mismatch the measurement sofware cannot communicate with the modules.



FAQ General

Questions and answers on CSM products.


FAQ CAN

Questions and answers on CSM CAN Modules.


FAQ ECAT

Questions and answers on ECAT Measurement modules.


FAQ ECM

Questions and answers on Exhaust Measurement Modules.


FAQ CSMconfig

Questions and answers on our Software CSMconfig.


FAQ UniCAN

Questions and answers on UniCAN data loggers.


FAQ INCA AddOn CAN/ETH

Questions and answers on our software INCA AddOn CAN/ETH.