UniCAN 3 ETH Data Logger

Data logger for mobile applications with Ethernet interface

The UniCAN 3 ETH is a compact and robust data logger for the acquisition of data from various sources: With the Ethernet interface, nine CAN interfaces, digital inputs and outputs and numerous data transmission options, it can be used flexibly in any measurement task.

Measurement data from ECUs, vehicle buses and also CSM MiniModules are reliably recorded via the Ethernet interface and CAN. With optional extensions for supported CAN protocols and other features (CANsend, CAN Stimulation...), the data logger can be configured for specific applications.

The configuration software CSMuniconf is used to configure the data logger and to verify proper operation via live monitoring. CSMdataconv allows easy (automated) management and conversion of even larger data quantities, as they may occur during fleet operation.

Key-Features

Overall

• AUTOSAR PDU support
• Very low power consumption (Operation and Stand-by)
• Display for visualization of device status and error codes
• Verification of configuration and data recording via Live Monitoring

Ethernet interface

• Data acquisition from ECUs
• Data from CSM ECAT MiniModules can also be recorded via an XCP-Gateway
• IEEE 10BASE-T, IEEE 100BASE-TX
• Acquisition of Ethernet Frames (UDP or TCP)
• Support of XCP-on-Ethernet (UDP)

9 CAN interfaces

• Data acquisition from CSM CAN MiniModules, ECUs and buses
• Support of CCP, XCP-on-CAN, CCP Block Read, OBD2 / EOBD, J1939
• Optional support of CAN FD for all CAN interfaces
• Optional support of Wake-on-CAN with no message lost, configurable per interface
• Optional isolated CAN Bus

4 digital I/O interfaces

Flexible data recording and transmission

• Encryption levels for increased protection of recorded data
• Exchangeable CF card up to 64 GB
• Available hardware options:
  • GPS receiver with detached antenna
  • LTE modem (+ UMTS / EDGE / GPRS)
  • WLAN module (WPA2-Enterprise (RADIUS) and WPA2-Personal (PSK)