Skip to main content

High-Voltage Safe Measurement Systems High-Voltage Safe Measurement Systems

HV IEPE3 ECAT TBM Series

Measurements with IEPE sensors

Type FL100

The FL100 has been specifically designed for measuring analog voltages from IEPE sensors, such as triaxial accelerometers, in high-voltage environments.

Highlights

  • Safe measurement of acceleration, force and pressure with IEPE sensors in high-voltage environments
  • Compatible with all common IEPE sensors such as microphones, vibration, torque, etc.
  • 3 analog inputs with reinforced insulation
  • High-voltage safe sensor excitation
  • Measurement data rate up to 100 kHz per channel
HV IEPE3 FL100
HV IEPE3 FL100

Description

The FL100 is equipped with three analog inputs and provides a modified sensor excitation for the connection of IEPE sensors. If combined with special sensor cables, standard IEPE sensors, which are typically used in low-voltage applications, can now be safely operated even in high-voltage environments. This allows customers to re-use their investment in standard sensors.

As a slide-in unit for 19-inch DIN racks, this measurement module is ideal for use on test benches. Combined with the optional mounting frame and IP65 rating, the HV IEPE3 FL100 is a good choice for mobile use in vehicles, allowing it to be mounted securely inside a vehicle’s trunk or passenger compartment.

Technical data

HV IEPE3 FL100
Inputs 3 analog inputs
Measurement ranges ±200, ±500 mV, ±1, ±2, ±5 V
Measurement data rate per channel 1, 2 , 5 , 10, 20, 50, 100 kHz
Sensor excitation per module, shared by all three analog inputs, galvanically isolated from module power supply
Voltage 24 V DC
(cannot be switched off)
Current typ. 3.5 mA per channel
(constant current)
Operating conditions
Nominal working voltages up to ±846 V
Housing protection class IP65
Operating temperature range -40 °C to +85 °C
Pollution degree 3
HV IEPE3 FL100 front view
HV IEPE3 FL100 front view
HV IEPE3 FL100 side view
HV IEPE3 FL100 side view

Applications

The HV IEPE3 FL100 is particularly suitable for measurements in durability testing: acceleration, force and pressure can be measured safely and easily on test bench and in vehicle tests.

Downloads


English
V.3.0.3
9.63 MB

English
V.1.0.0
284.58 KB


English
V.1.0.0
397.25 KB


English
V.1.0.1
427.68 KB

English
V.1.1.1
344.12 KB

English
V.1.5.2
1.38 MB


English
V.2.0.0
405.05 KB
This example shows how accelerations inside and outside a high-voltage battery pack are measured during a drop test to verify vehicle safety. CSM measurement technology offers a simple solution...


V.1.04
1.78 MB
Firmware for HV IEPE3 ECAT TBM, HW revision A
Multilanguage
V.9.8.0
389.14 MB
    {lang en}
  • Configuration software for CSM measurement modules (incl. documentation)
  • with visualization software CSMview
  • System requirements:
...