New tests for electric vehicles and their components are intended to ensure the safety of passengers and systems and are a basic requirement for approval on various markets. One example is a drop test for high-voltage batteries, which is mandatory for verification for the Korean market. The following example shows how the necessary acceleration measurements inside and outside the high-voltage battery are performed during the drop test.
Drop tests must be carried out to ensure that HV battery packs do not explode or catch fire in the event of an accident. International standards differ from each other in this respect and stipulate, for example, different drop heights, battery charge levels and surfaces that the pack hits.
|Standard||SAE J2464||SAE J2929||UL 2580||USABC||FreedomCAR||KMVSS 18-3||QC/T 743|
|Drop Height (m)||2||≥ 1||1||10||≥ 10||4.9||1.5|
|Surface||Flat Surface||Concrete||Cylindrical Steel Object||Concrete||Wood|
|Battery Charge Level (in %)||95 - 100||Maximal||100||80||100|
Tab 1: Comparison of international standards for a drop test of HV batteries (November 2019 - subject to correction)
In this example, a drop test is performed according to the Korean "Korea Motor Vehicle Safety Standard" (KMVSS): The specified drop height is 4.9 meters, from which the battery pack with a state of charge of 80 % shall hit a concrete surface.
Synchronous measurement of accelerations inside and outside a high-voltage battery during a drop test.
During the drop test, the acceleration has to be measured at various points inside and outside the battery in order to record the acting forces. The sensor data from the accelerometers inside the battery must be recorded in a high-voltage safe manner and synchronously with the values measured on the outside of the battery. In order to register even small dynamics of the acting forces during fall and impact, it must be measured with a high measurement data rate.
With this measurement technology solution, the drop test can be carried out and the forces acting in the process can be recorded precisely and synchronously. The combination of measurements of conditions inside and outside the battery pack in a single measurement chain has enormous advantages in terms of synchronization and subsequent evaluation of the data.
Thanks to the CSM safety concept and high-voltage safe measurement technology, it is also possible to use standard sensors designed for low-voltage applications.
Here you find the complete application report for download as PDF.
Electromobility continues to gain momentum. Various energy storage, drive and charging systems pave the way to electric mobility. The development of high-voltage batteries, inverters and electric motors places high demands on measurement technology in order to obtain the right results for further optimization. Together with Vector Informatik, CSM has developed a measurement system that leaves nothing to be desired.
XCP-Gateway is the interface between the data acquisition software (e. g. vMeasure, CANape®, INCA®, Vision® ...) and the EtherCAT® measurement modules from CSM. It includes an EtherCAT® master and an XCP-on-Ethernet slave.
Swift configuration of measurement chains: CSMconfig is the reliable configuration software for all CAN and EtherCAT® based measurement modules from CSM. The clearly arranged and easy-to-use user interface allows an easy setting of all measurement parameters. This helps speeding up the measurement setup considerably.
vMeasure exp, developed by Vector Informatik, is an easy-to-use software tool for the acquisition and analysis of measurement data that can be used in combination with all CAN- and EtherCAT®-based CSM measurement modules. CSMconfig was integrated directly to ensure swift configuration.